In the majority of cases, most people spend quite a bit of money purchasing their lift truck. Hence, it is really important to take good care of it so as to protect your investment well into the long run. It is really a good idea to know the procedures that are undertaken in taking care of and maintaining this machine.
By starting up the forklift and listening closely how it works is one of the best ways to tell how good the engine is working. Like for example, if there are any misses or knocks, the equipment is defective and this should raise several concerns. Additionally listen closely for any squealing sounds which come from the belts since these sounds will provide you with a lot of information.
Several of the main parts requiring attention during maintenance comprise the gauges, horn, safety warning devices, the overhead guard and the lights. Any faulty components or burnt out light bulbs have to be replaced as soon as they are noticed. It is also imperative to check the wiring.
After the above parts have been checked carefully, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Every cell of the battery should be checked so as to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and then change the filters. The hydraulic filter, the transmission filter and the fuel filters should be frequently replaced. Before fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
When the oil change has been completed and new filters have been fitted, visually check the drive axle from underneath the machinery. Be certain to grease the axle if there is any grease fitting. Check the belts on the engine for any cracks or frays. If you find any, fix the problem accordingly. Afterwards, inspect every other part of the machine including the wheels. If any type of problem or fault is detected, be sure to address it immediately in order to make sure the machinery is running at its safest and optimum levels.